请高手帮我分析一下
Uncompressing Linux............................................................................... done, booting the kernel.
Linux version 2.6.22 (root@HostWi) (gcc version 4.2.3 (Sourcery G++ Lite 2008q1-126)) #7 Mon Jan 16 00:04:36 PST 2012
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
Machine: Atmel AT91SAM9260-EK
Memory policy: ECC disabled, Data cache writeback
Clocks: CPU 198 MHz, master 99 MHz, main 18.432 MHz
CPU0: D VIVT write-back cache
CPU0: I cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets
CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets
Built 1 zonelists. Total pages: 8128
Kernel command line: init=/linuxrc root=/dev/mtdblock3 rootfstype=yaffs2 console=ttyS0,115200 mem=32M
AT91: 96 gpio irqs in 3 banks
PID hash table entries: 128 (order: 7, 512 bytes)
Console: colour dummy device 80x30
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 29908KB available (2204K code, 217K data, 104K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
NET: Registered protocol family 16
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NetWinder Floating Point Emulator V0.97 (double precision)
io scheduler noop registered
io scheduler anticipatory registered (default)
atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERIAL
atmel_usart.1: ttyS1 at MMIO 0xfffb0000 (irq = 6) is a ATMEL_SERIAL
atmel_usart.2: ttyS2 at MMIO 0xfffb4000 (irq = 7) is a ATMEL_SERIAL
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
macb macb: detected PHY at address 0 (ID 0181:b8b0)
eth0: Atmel MACB at 0xfffc4000 irq 21 (3e:36:65:ba:6f:be)
SSFDC read-only Flash Translation layer
No valid DiskOnChip devices found
NAND device: Manufacturer ID: 0x98, Chip ID: 0x39 (Toshiba NAND 8MiB 1,8V 8-bit)
flash size: 8 MiB
page size: 512 bytes
OOB area size: 16 bytes
sector size: 8 KiB
pages number: 16384
pages per sector: 16
bus width: 8
bits in sector size: 13
bits in page size: 9
bits in OOB size: 4
flash size with OOB: 8448 KiB
page address bytes: 3
sector address bytes: 2
options: 0x62
Scanning device for bad blocks
Creating 1 MTD partitions on "NAND 8MiB 1,8V 8-bit":
0x00000000-0x00800000 : "NAND simulator partition 0"
NAND device: Manufacturer ID: 0xec, Chip ID: 0x76 (Samsung NAND 64MiB 3,3V 8-bit)
NAND_ECC_NONE selected by board driver. This is not recommended !!
Scanning device for bad blocks
Bad eraseblock 689 at 0x00ac4000
Bad eraseblock 690 at 0x00ac8000
Bad eraseblock 691 at 0x00acc000
……….N 个
Bad eraseblock 692 at 0x00ad0000
Bad eraseblock 853 at 0x00d54000
Bad eraseblock 854 at 0x00d58000
Creating 5 MTD partitions on "NAND 64MiB 3,3V 8-bit":
0x00000000-0x00001000 : "Bootstrap"
mtd: partition "Bootstrap" doesn't end on an erase block -- force read-only
0x00001000-0x000a0000 : "u-boot"
mtd: partition "u-boot" doesn't start on an erase block boundary -- force read-only
0x000a0000-0x00aa0000 : "kernel"
0x00aa0000-0x014a0000 : "fs"
0x014a0000-0x04000000 : "user space"
usbmon: debugfs is not available
at91_ohci at91_ohci: AT91 OHCI
at91_ohci at91_ohci: new USB bus registered, assigned bus number 1
at91_ohci at91_ohci: irq 20, io mem 0x00500000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
udc: at91_udc version 3 May 2006
mice: PS/2 mouse device common for all mice
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
yaffs: dev is 32505859 name is "mtdblock3" rw
yaffs: passed flags ""
VFS: Mounted root (yaffs2 filesystem).
Freeing init memory: 104K
Warning: unable to open an initial console.
Failed to execute /linuxrc. Attempting defaults...
Kernel panic - not syncing: No init found. Try passing init= option to kernel.
请问这是什么原因呀？请高手们帮我分析分析，谢谢! 我每次都结帖，给分的哦…快过年了，先给大家拜早年了。
我是64M的nandflash，yaffs文件系统在NFS上挂载成功的，然后就用mkyaffsimage把那个挂载成功的系统文件夹制作一个文件系统bin文件，通过wrtie.yaffs烧录到flash中，内核也选择了 let yaffs do it’s own ECC啥的，ECC_NONE也改了，到底哪一步出差了？谢谢
NFS挂载成功是否表明系统文件没问题？
[解决办法]
Warning: unable to open an initial console.
Failed to execute /linuxrc. Attempting defaults...
Kernel panic - not syncing: No init found. Try passing init= option to kernel.
说实话没玩过嵌入式...不过只看提示的话，我想是内核没有在/linuxrc这里面找到合适的shell
我猜......init这个参数后的路径给错了。。。
[解决办法]
